Interview Question in Op-Amps


 

Interview Question :: What is vartual-ground in OP-AMPS


Virtual ground (sometimes called virtual earth) is an important concept found in electronic circuit designs. It identifies a point in a circuit as being held close to the circuit's ground or reference level electric potential. Creation of a virtual ground is due to the actions or effects of the parts in the circuit. It is called virtual since this point does not have any real electrical connection to ground. The reference may or may not be the same as the local utility ground or earth.

Overview:
The virtual ground concept aids circuit analysis in operational amplifier and other circuits and provides useful practical circuit effects that would be difficult to achieve in other ways. An ideal virtual ground would be able to source/sink an infinite amount of current. In practice, the sourcing/sinking capability is determined by the other circuit impedances and the amplifier used.

How to create a virtual ground point:
Since an operational amplifier has very high open loop gain, in negative feedback circuits the amplifier acts automatically to make the potential difference between its inputs tend to zero. Consider the simple inverting configuration below. If the non-inverting (+) input of the operational amplifier is grounded, then its inverting (-) input, although not connected to ground, will assume a similar potential, becoming a virtual ground.

Virtual ground used as a summing point:
A virtual ground presents a very low impedance to any signal connected to it and it therefore provides the perfect type of input for current type signal sources. It can therefore be used to sum input signals using an op-amp as shown below. It also provides isolation of the input signals.

In electrical distribution networks:
Three-phase electrical "Y" (or star) circuits are said to have a virtual ground node when their sources and loads are balanced respectively. The virtual ground in this case exists at the star point.

Source(s):
http://en.wikipedia.org/wiki/virtual_gro...

For more pl. visit:

http://tangentsoft.net/elec/vgrounds.htm...
Answers to "What is vartual-ground in OP-AMPS"
RE: What is vartual-ground in OP-AMPS?

You use an op-amp to create a regulated voltage level that is mid-way between the supply rails.



The real utility is that it allows you to create bi-polar supplies from a single voltage. For example, if you have a +24 V supply, you can use op-amps to create a "virtual ground" at, say, 19 V above the negative rail. Now, with respect to the virtual gound, the (+) lead of the 24V supply is a +5 supply, and the (-) lead of the 24V supply is a -19V supply. More commonly, you would probably split your 24V into +12 and -12 by putting the virtual ground midway between the rails.



The virtual ground is different from a simple resistive voltage divider because the op-amp provides an active element that allows you to maintain the potential of the virtual ground over a wide range of load current. (However, you might use a resistive divider to set the reference voltage for the virtual ground.)
 
Vote for this answer ::  
RE: What is vartual-ground in OP-AMPS?

Virtual ground in an op-amp circuit identifies a point being held close to the circuit's group or reference potential.



Creation of a virtual ground is due to the actions or effects of the parts in the circuit. It is called virtual since this point does not have any real electrical connection to ground.



Here's a good explanation for you to read:

http://en.wikipedia.org/wiki/Virtual_gro...
 
Vote for this answer ::  
Update Alert Setting
Advertisement2